Description
ARA Mark2-V2 Motor
- Lowest Prices in Australia Guaranteed
- 100% Satisfaction Guarantee
- 5 Year Motor Warranty
- 2 Year General Warranty
- Suitable for All Sectional/ Panel Doors
- Heavy Duty – 1000 nm maximum output!
ARA Fingerprint Remote Control
- 12 Months ARA Warranty
- Compatible for Gates & Garage Door Motors
- Up to 30 User Fingerprint
- 4 Channels to Operate 4 Door Openers
- Waterproof and Suitable for Indoor or Outdoor
- No Keys/ Remotes Needed
- Security at its Best
FEATURES
ARA Mark2-V2 Motor
- Soft Start & Stop – which is a function that accelerates and reduces the speed at the beginning and end of the cycle which significantly reduces the stress put onto the motor, increasing its life expectancy.
- The Mark2-V2 motor has an automatic close function which can only be utilized if installed with Photo Beam sensors.
- The Mark2-V2 motors offer as much power as the older AC Motors but with drastically reduced noise and vibration, offering smooth and reliable operation without the strenuous noise.
- Standby Power Usage – Our motor is the one of the lowest standby power consuming units in Australia.
- Space Efficiency – The Mark2-V2 is a very compact which allows it to be fitted even when headroom is limited.
- Imbalanced Sensors – The unit monitors the spring balance of the door, and will indicate when the door is out of balance through a flashing LED light every 15 seconds, once the imbalance is detected.
- The garage will be illuminated once the motor is engaged and will automatically turn off after 2 minutes has lapsed.
- Vacation Mode Disables push button functionally to provide utmost security whilst user is absent for extended periods of time.
- Anti-Collision Safety sensor – Should your door be interrupted while in its motions, it will automatically reverse to avoid injury in shutting on someone, or causing damage to any goods or vehicles.
- Manual Disengagement allows you to open and close your garage door manually in the event of power failure.
- Support Original Steering Wheel Control.
ARA Fingerprint Remote Control
- The buzzer beeps after power on, if the green light flash for 1 second, it means the fingerprint module normally works; if the red and green light flash alternately, it means communication error, please verify that the fingerprint module is normal and its connection is correct, otherwise, the device cannot work.
- There are 4 output channels inside, to control the corresponding channels signal output by registering fingerprints.
- Set up a manager fingerprint to manage users’ fingerprint registration, channel selection and the deletion of all registered fingerprints. Note that the manager fingerprint cannot be used as users’ fingerprint.(it cannot control signal output).
- When the user press the fingerprint and after it’s valid, the corresponding channel will output signal for 1 second, at the same time the green light will flash for 1 second, and the buzzer beeps for 1 second. If the fingerprint is invalid, the buzzer beeps 4 times.
- Low battery detection: press fingerprint in standby status, if the red light quickly flash for about 2 seconds, it indicates low battery, please replace battery.
INSTALLATION
- D.I.Y Installation Manual to assist a handyman with the installation of the MARK2-V2 unit, however ARA Recommends a professional Installer to carryout the installation of your garage door motor!
- Installation is available within Melbourne Metropolitan
- Please call 1800 27 22 27 to clarify whether your area is covered
- The ARA Mark2-V2 Motor comes with 7 years full warranty if it is installed by ARA trained staffs for your peace of mind
SPECIFICATIONS
Mark2-V2 Motor:
- 433.22 Mhz AM radio with rolling code (1.2 billion combinations)
- Input Voltage: 240V AC
- 24V DC Motor
- Pulling Force: 800 nm Continuous, 1000 nm max output!!!
- LED Display Screen
- Light: 24V 21W incandescent
- 24V Accessory Output
- Transmitter: 27A 12V Battery
- Working Temperature -20°C to +50°C
- Relative Humidity: <= 90%
ARA Fingerprint Remote Control
- Power: 4 x AA alkaline battery
- Life of battery: 1 year (use 10 times every day) 3.Frequency: 433.22 Mhz +/-75 Kh
- Transmitting power: approx 10Mw
- Code: HCS301 standard
- Working distance: 100m outdoor and 30m indoor 8.IP grade: IP54
- Working temperature: -20℃ to 55℃
Reviews
There are no reviews yet.